64ACC1368 Datalogic CVR2 Replacement Battery 3.7V 1000mAh

Datalogic CVR2 / Memor Series — 3.7V Li-ion Replacement Battery (64ACC1368)

This 3.7V, 1000mAh Li-ion battery replaces part numbers 64ACC1368, 94ACC1367, and 94ACC1368 in the Datalogic CVR2, DL-Memor, and Memor handheld barcode scanners. These scanners are common in retail, warehouse, and logistics pick-and-pack operations where daily battery cycling is heavy. Dimensions are 64.70 × 37.00 × 7.40mm — a direct match to the original cell footprint.

• CVR2, DL-Memor, and Memor compatibility: All three models share the same battery bay geometry, contact arrangement, and BMS communication protocol. One cell fits all three without modification.
• Bench tested on actual hardware: We ran this pack through charge and discharge cycles on the CVR2 platform. The BMS handshake completed cleanly, cell voltage held steady through repeated scan-trigger inrush events, and charging communication with the cradle registered correctly.
• First-shift preparation for pick-and-pack use: After installing a fresh pack, place the scanner in its cradle and run a full charge cycle before using it on the floor. Scan-trigger inrush current is highest when the cell is near minimum charge, and starting below threshold can cause the BMS to trip on the first active shift.

Cradle charging error on a new pack

When a new battery shows a charging fault on the cradle, the most common cause is contact resistance at the battery terminals — not a faulty cell or dock. Oils, dust, and residue from handling transfer onto the gold contacts during installation. Wipe the battery contact strip with a dry, lint-free cloth, reseat the scanner firmly in the cradle, and confirm the charge indicator activates. If the error clears, the pack was fine; the contacts just needed cleaning before the dock could read pack voltage.

Scanner dropping wireless connection during rapid scan bursts

The CVR2 and Memor draw current simultaneously from the wireless radio and the scan trigger during fast barcode reads. On a degraded or low cell, this combined inrush can pull voltage below the BMS protection threshold, causing the radio to drop momentarily and the scanner to lose its access point connection. A fresh, fully charged pack raises the voltage floor and keeps both loads stable through burst scanning. If dropouts persist with a charged pack, check that the cradle contact pins are clean and seating fully — a poor contact raises effective resistance and amplifies the sag.