Ikohs Create Netbot S10 Replacement Battery 14.4V 2600mAh

Ikohs Create Netbot S10 / S12 / S14 / S15 — 14.4V Li-ion Replacement Battery

This is a 14.4V, 2600mAh Li-ion replacement battery for the Ikohs Create Netbot S10, S12, S14, and S15 robotic vacuum cleaners. It fits directly into the battery bay and powers the drive motors, suction fan, and onboard electronics. Swap it when the original cell no longer holds enough charge to complete a full cleaning run.

• Netbot S10 through S15 platform fit: These four Netbot models share the same 14.4V battery format, connector pinout, and BMS communication protocol — one replacement cell covers all four variants without modification.
• Bench tested on actual hardware: We cycled this cell through charge and discharge on the Netbot platform and confirmed the BMS handshake initialised correctly, protection thresholds triggered at expected voltage levels, and the dock charge circuit accepted the cell without fault codes.
• Dock charging habit on robotic vacuums: Do not leave the Netbot sitting on the charging dock between cleaning sessions indefinitely. Continuous trickle charging accelerates capacity fade in Li-ion cells used in low-draw robotic vacuum circuits. Charge to full, then lift the unit off the dock.

Cordless vacuum losing suction before battery indicator reaches low

When the suction fan motor draws more current than the cell can deliver cleanly, voltage sags at the pack level — even if the state-of-charge indicator still reads mid-range. This happens most often when the filter is partially blocked, forcing the motor to work harder against restricted airflow. The BMS reads voltage, not airflow resistance, so it does not flag a fault. Clean the filter first, then retest suction performance across a full charge cycle.

Motor cutting out mid-clean and recovering after a short pause

This is a BMS overcurrent trip, not a dead battery. When suction is restricted — blocked brush roll, clogged filter, or heavy carpet fibres — the motor draws a sustained spike above the BMS current threshold and the pack shuts the output rail to protect the cell. After a brief rest, internal temperature drops and the BMS resets, restoring power. Clear the brush roll and filter, then confirm resting pack voltage reads at least 16.0V off charge before ruling out a cell fault.