Iloa 95 Cordless Phone Replacement Battery 3.6V 300mAh

Iloa 95 / 350 / 352 / 480 Series — 3.6V Ni-MH Replacement Battery

This is a 3.6V, 300mAh Ni-MH rechargeable battery for the Iloa 95, 350, 352, and 480 cordless phone handsets. It replaces the original internal pack when talk time has dropped or the handset no longer holds a charge. Dimensions are 30.00 × 32.00 × 10.50mm — confirm your existing pack matches before ordering.

• Cross-model fit — 95, 350, 352, 480: These four handset models share the same battery footprint, connector orientation, and 3.6V cell stack. Swapping between them does not change the pack specification.
• Bench tested on actual hardware: We ran this pack through charge and discharge cycles on a NiMH-compatible test rig. The cell voltage held within spec across all cycles, and there were no BMS rejection events during the charge acceptance window.
• First-charge protocol for NiMH handsets: After installing, seat the handset in the base station and leave it for a full 16 hours before first use. NiMH cells ship in a partially discharged state — a slow initial charge is what brings them to rated capacity. Pulling the handset off the base after a quick charge will give you a fraction of what this pack can actually deliver.

Why talk time stays short for the first few cycles after a battery swap

NiMH cells do not reach full capacity on the first charge cycle. It typically takes three to five full charge-and-discharge cycles before the pack delivers its rated 300mAh. This is a chemistry characteristic, not a defect. If talk time is still noticeably short after five complete cycles, check that the handset is making solid contact with the base charging pins.

Base station shows no charge light after new pack installed

NiMH packs can drop to a low resting voltage during storage — sometimes low enough that the base station's charge controller does not recognise a valid battery on the first seating. Remove the handset from the base, wait ten seconds, and reseat it firmly. If the charge indicator still does not activate, check that the handset contacts and base pins are clean and free of oxidation. A quick wipe with a dry cloth on both contact points resolves this in most cases. The base should show a charge light once the pack voltage reads above approximately 3.0V.