ZTE MF935 Li-ion Replacement Battery 3.8V 2000mAh

ZTE MF935 — 3.8V Li-ion Replacement Battery (Li3820T44P4h665055)

This is a 3.8V, 2000mAh Li-ion battery for the ZTE MF935 portable wireless hotspot. It replaces part number Li3820T44P4h665055 and fits the MF935 directly. Dimensions are 66.10 x 50.00 x 5.60mm, matching the original cell footprint.

• MF935 platform fit: The MF935 runs its cellular modem and Wi-Fi radio from a single 3.8V cell. This battery matches that voltage rail and the BMS communication protocol the hotspot uses to monitor charge state and trigger low-battery shutdown.
• Bench tested on actual hardware: We cycled this cell under combined modem and Wi-Fi load at maximum connected devices. The BMS held the protection thresholds correctly — no spurious cutoff at the 3.2V floor and no overcharge above 4.2V.
• Cellular signal and thermal load: Keep the MF935 in an open, ventilated spot during long sessions. When the device is far from connected clients or in a weak signal area, the cellular radio runs at full transmit power — this drives battery temperature up and accelerates cell wear over time.

Why the MF935 drops connected devices mid-session under a new battery

When multiple clients are active simultaneously, the combined draw from the LTE modem and the Wi-Fi radio can spike hard enough to sag cell voltage below the BMS protection threshold. The hotspot reads this as a low-battery event and resets the radio stack, which disconnects all clients. This is not a faulty battery — it is a BMS trip caused by instantaneous current demand. Reduce the number of active clients or move the hotspot closer to the cellular tower to cut transmit power and keep voltage above the 3.2V cutoff floor.

MF935 not powering on after sitting unused for weeks

Li-ion cells self-discharge at roughly 1–2% per week in storage. If the MF935 sits unused long enough, the battery can drop below the minimum boot voltage the device requires to initialise — typically around 3.0V for this class of hotspot. The device will show no response at all when the power button is pressed, which looks like a dead unit. Connect the charger and leave it for at least 20–30 minutes before attempting to power on; the BMS needs enough charge to exit deep-discharge mode and allow the boot sequence to start. If the charge LED does not activate within five minutes of connecting power, check the charging cable and adapter output — the MF935 requires a stable 5V supply to recover a deeply discharged cell.