Acer ConceptD 3 AP19D5P Replacement Battery 15.4V 4750mAh

Acer ConceptD 3 CN315-72G Series — 15.4V Li-Polymer Replacement Battery (AP19D5P)

This is a 15.4V, 4750mAh (73.15Wh) Li-Polymer replacement battery for the Acer ConceptD 3 CN315-72G-70P5 and related CN315-72G, CC314-72G models. It uses OEM part number AP19D5P and connects directly to the existing power rail in this 15.4V notebook platform. When the original cell degrades, this restores full charge capacity to the machine.

• ConceptD 3 CN315-72G platform fit: These models share a common 15.4V four-cell Li-Polymer architecture and the same AP19D5P connector and BMS handshake spec. The fuel gauge IC expects a cell rated at 73.15Wh — this battery matches that figure so BIOS reads capacity correctly after calibration.
• Bench tested on actual hardware: We ran this cell through charge and discharge cycles on the CN315-72G platform. The BMS accepted the replacement without firmware rejection, and the charge controller reached full termination at 16.8V as expected for a 15.4V nominal four-cell pack.
• First-cycle calibration after install: After fitting this battery, run one full discharge until the laptop hibernates on its own, then charge uninterrupted to 100%. This forces the BIOS battery learn cycle to reset against the new cell and clears the inaccurate health warning that appears on nearly every cell swap in this series.

ConceptD 3 shutting down at 20–30% charge under GPU and CPU load

The CN315-72G carries both a discrete GPU and a high-draw CPU. Under sustained rendering or video export, combined draw can pull the cell voltage into a sharp cliff before the OS gauge reaches 0%. The BMS interprets this voltage drop as a critically low cell and triggers an emergency cutoff to prevent damage. This is not a faulty battery — it is the fuel gauge IC losing track of the actual state of charge because the EEPROM data from the old cell is still influencing the estimate. Run two full learn cycles and the cutoff threshold will shift to the correct point.

BIOS reporting wrong Wh rating after AP19D5P swap

After a cell swap, the BIOS may display a Wh figure that does not match the 73.15Wh spec of this battery. This happens because the EEPROM in the old cell stored a different rated value, and the system cached that figure. The new cell broadcasts its own EEPROM data, but the BIOS does not always flush the cached value until a full learn cycle is completed. Discharge fully to hibernate-cutoff, charge to 100% uninterrupted, and the reported Wh will update to reflect the AP19D5P spec.