Coolpad 7232 Replacement Battery CPLD-119 3.7V 1200mAh

Coolpad 7232 — 3.7V Li-ion Replacement Battery (CPLD-119)

This is a 3.7V, 1200mAh Li-ion replacement cell for the Coolpad 7232 smartphone. It uses OEM part number CPLD-119 and fits the 7232 directly. Dimensions are 65.80 × 51.72 × 4.15mm — verify these against your existing cell before installing.

• Coolpad 7232 fitment: The 7232 uses a removable rear-access cell with a fixed connector orientation. This cell matches that connector pinout and the voltage rail the phone's charge IC expects. No modification needed.
• Bench tested on actual hardware: We ran charge cycles on this cell and confirmed the BMS communicates correctly with the charge IC. Charge acceptance was normal across the full 3.7V nominal range, and the protection circuit triggered correctly at the low-voltage cutoff threshold.
• First cycle after installation: On first use, disable any fast-charge setting and run one complete discharge-to-charge cycle before resuming normal charging. This lets the phone's fuel gauge IC map the new cell's discharge curve before high-current charging pushes into an uncalibrated state.

Sudden shutdown at 20–30% on the Coolpad 7232 after a cell swap

This happens because the fuel gauge IC still holds calibration data from the old, degraded cell. The new cell has a different discharge curve, so the percentage reading drifts early and the phone hits the hardware low-voltage cutoff before the display reaches 0%. It is not a fault with the replacement cell — it is a calibration mismatch. Run two full discharge-to-charge cycles without interruption and the fuel gauge IC will recalibrate against the new curve.

Phone shows wrong battery percentage after fitting the CPLD-119

The coulomb counter inside the Coolpad 7232 tracks charge based on historical cell data. A new cell resets that history, so the reported percentage can jump or read inaccurately for the first few cycles. This is not a defective reading — the IC simply needs new reference points. Drain the battery fully until the phone shuts off, then charge uninterrupted to 100% twice. After two full cycles the percentage display stabilises.