Dell Precision 5530 2-in-1 Replacement Battery 11.4V 6500mAh

Dell Precision 5530 2-in-1 — 11.4V Li-Polymer Replacement Battery (0TMFYT)

This is an 11.4V 6500mAh (74.1Wh) Li-Polymer battery for the Dell Precision 5530 2-in-1 and XPS 15-9575 series. It replaces OEM part numbers 0TMFYT, 8N0T7, FW8KR, and TMFYT. If your original cell is swelling, failing to hold charge, or the BIOS is flagging degraded health, this is the direct swap.

• Precision 5530 2-in-1 and XPS 15-9575 compatibility: Both the Precision 5530 2-in-1 and XPS 15-9575 variants share the same 11.4V three-cell Li-Polymer pack format, connector pinout, and BMS handshake protocol — which is why a single part number covers all listed models.
• Bench tested on actual hardware: We ran this cell through charge and discharge cycles on the Precision 5530 2-in-1 platform. The BMS handshake completed on first boot, and the fuel gauge IC initialised without error flags.
• First-cycle calibration after install: After fitting this battery, run a full discharge to hibernate cutoff, then charge uninterrupted to 100%. This resets the BIOS battery learn cycle and clears the inaccurate health warning that appears after every cell swap on Dell systems.

BIOS reporting battery health as poor immediately after replacement

The Precision 5530 2-in-1 BIOS reads health data from EEPROM stored on the old cell during every boot. When a new cell is installed, the EEPROM contains no accumulated cycle data, and some Dell firmware versions interpret this as a degraded or unknown pack. This is not a fault with the replacement cell. Run one full discharge-to-hibernate followed by a complete uninterrupted charge to 100% — this forces the BIOS battery learn cycle to write fresh baseline data to the new cell's EEPROM and clears the warning on next boot.

Laptop shuts down abruptly at 20–30% shown on the fuel gauge

This happens when the fuel gauge IC is still calibrated to the old cell's discharge curve. The new Li-Polymer cell has a different voltage-to-capacity relationship, so the gauge reads 25% while the cell voltage has already dropped below the BMS cutoff threshold under full CPU and display load. The laptop cuts out because the cell cannot sustain voltage during peak draw — not because it is empty. Run two full discharge and charge calibration cycles, and the fuel gauge IC will remap its curve to the new cell. After the second cycle, shutdown should align with the gauge reading dropping below 5%.