JBL J56BT Wireless Headset Compatible Battery 3.7V 450mAh

JBL J56BT — 3.7V Li-Polymer Replacement Battery (FT582535P)

This 3.7V, 450mAh Li-Polymer cell replaces the original battery in the JBL J56BT wireless Bluetooth headset. It fits the compact on-ear form factor and restores power when the existing cell no longer holds a charge. Dimensions are 36.28 × 24.70 × 5.40mm — measure your old cell before installing.

• J56BT platform fit: The J56BT runs a single-cell Li-Polymer pack at 3.7V nominal. This replacement matches that voltage rail and the original connector orientation, so the BMS handshake completes without an error flag on power-up.
• Bench tested on actual hardware: We cycled this cell through charge and discharge on the J56BT platform. The BMS accepted the new pack on the first connection, and the protection circuit tripped correctly at the low-voltage cutoff threshold — no false shutdowns observed.
• First-cycle charging on the J56BT: Seat the headset in its charging cradle immediately after fitting the new cell and let it complete a full charge cycle before use. The J56BT's firmware uses that first cycle to log the new cell capacity — skip it and the battery indicator will read inaccurately for several days.

Why the J56BT cuts out mid-call even with a new battery

The J56BT draws current from two loads simultaneously during a call — the Bluetooth radio and the audio amplifier. On a cell that hasn't completed its first few charge cycles, internal resistance is still elevated. That resistance causes a brief voltage sag under the combined draw, and the BMS reads it as an undervoltage fault. The fix is to complete three to five full charge-discharge cycles before heavy use — internal resistance drops as the cell conditions, and the sag narrows.

Base station shows full charge but headset shuts off after a few minutes

A freshly installed Li-Polymer cell ships at storage voltage — typically around 3.6V to 3.8V, not a true full charge. The base station's charge circuit may terminate early if it reads that voltage as "already full." Place the headset in the cradle, remove it, then reseat it firmly to force the charger to restart its cycle. If the charge indicator comes on and runs to completion, the cell will hold a full charge and the early shutoff will stop.