King Cleaning od TV 14.4V Ni-MH Replacement Battery 2000mAh

King Cleaning od TV — 14.4V Ni-MH 2000mAh Replacement Battery

This is a 14.4V Ni-MH replacement battery rated at 2000mAh (28.8Wh) for the King Cleaning od TV cordless vacuum. It slots into the vacuum's battery bay and restores power to the motor and suction system. Order this when the original cell no longer holds enough charge to complete a cleaning session.

• od TV platform fit: The od TV cordless vacuum runs a 14.4V motor rail. This cell matches that voltage requirement and the bay dimensions — 179 x 51 x 52mm — so the pack seats and connects correctly without modification.
• Bench tested on actual hardware: We cycled this pack through full discharge and recharge sequences on the bench. The BMS held stable across the cycle, with no premature cutoff under sustained motor load at rated current draw.
• Dock charging behaviour on Ni-MH cells: Do not leave the vacuum sitting on the charging dock once the battery is full. Ni-MH cells are more vulnerable to trickle-charge damage than Li-ion. Charge to full, then remove the vacuum from the dock and store it off the charger.

Suction dropping before the battery indicator reaches low

This happens when the motor is drawing more current than the pack can sustain cleanly. A partially blocked filter is the most common trigger — restricted airflow forces the motor to work harder, pulling higher current and causing voltage to sag under load. The battery indicator reads cell voltage at rest, not under load, so it can show mid-range while the motor is already starved. Clear the filter first, then recheck suction consistency across the full charge cycle.

Motor cuts out mid-use then recovers after a pause

This is a BMS overcurrent trip, not a dead battery. When the motor pulls current above the BMS threshold — usually caused by a blockage or heavily clogged filter — the protection circuit interrupts the circuit to prevent cell damage. The pack resets after a short rest period, which is why the vacuum starts again after you wait. Fix the restriction causing the high draw: clear the filter, check the brush roll for tangled debris, then run the vacuum again. If the cutout persists with a clean filter, verify the replacement pack's BMS trip threshold matches the od TV motor's rated draw.