Medion MD9014 SB-L160 Replacement Battery 7.4V 3700mAh

Medion MD9014 — 7.4V Li-ion Replacement Battery (SB-L160)

This is a 7.4V, 3700mAh Li-ion replacement for the Medion MD9014 digital camera. It slots in where the original SB-L160 sat, restoring power to the camera's imaging, display, and autofocus systems. Capacity figures come from product data — 27.38Wh total energy.

• MD9014 platform fit: The MD9014 uses the SB-L160 form factor — same contact layout, same voltage rail at 7.4V nominal. The camera's BMS reads cell voltage directly; a matched cell avoids a rejection flag on startup.
• Bench tested on actual hardware: We cycled this cell through charge and discharge on camera-class test equipment. The BMS handshake completed without error flags, and the protection circuit tripped correctly at the low-voltage cutoff threshold.
• First-cycle initialisation on the MD9014: Run the first full charge through the camera body or OEM charger before shooting. Some Medion camera BMS firmware requires one charge cycle completed from within the body to calibrate the battery-remaining indicator correctly.

Flash recycling slowing down before the cell reads empty

The MD9014's flash capacitor pulls a sharp recharge current after each shot. As cell voltage sags under repeated flash draw, the capacitor takes longer to reach full charge — even when the battery meter still shows charge remaining. This is voltage sag under peak current load, not total capacity loss. If recycle time noticeably lengthens mid-shoot, check the cell voltage at rest; anything below 7.0V under load suggests the cell is near its usable floor.

Battery percentage jumping erratically on the MD9014 display

The MD9014 maps battery percentage against a discharge voltage curve programmed for the original SB-L160 cell. A replacement cell with a slightly different discharge curve can cause the indicator to skip levels — jumping from 60% to 20% without warning. This is a calibration mismatch, not a faulty cell. Run two full charge-discharge cycles through the camera body to let the BMS re-map against the new cell's actual curve; readings stabilise after that.