Solac AE2510 Replacement Battery 14.4V 3000mAh Ni-MH

Solac AE2510 — 14.4V Ni-MH Replacement Battery (403884)

This is a 14.4V, 3000mAh Ni-MH replacement battery for the Solac AE2510 cordless handheld vacuum cleaner. It replaces OEM part number 403884. When the original cell degrades and suction drops noticeably, this cell restores the motor to its rated voltage draw.

• AE2510 voltage rail match: The AE2510 motor controller runs on a 14.4V nominal rail. Fitting a cell at the wrong voltage causes the controller to either refuse to start or run the motor undervolted, which cuts suction before the battery is actually depleted. This cell sits at the correct nominal voltage to keep the controller operating within spec.
• Bench tested on actual hardware: We cycled this cell under a sustained load matching the AE2510 motor draw. The BMS held cutoff voltage correctly and did not trip false overcurrent on startup. Cell temperature stayed within normal range across the discharge cycle.
• Dock charging on the AE2510: Do not leave the AE2510 sitting on the charging dock after it reaches full charge. Ni-MH cells on continuous trickle charge develop capacity fade significantly faster than cells charged only when depleted. Charge fully, then remove from the dock.

Cordless vacuum losing suction before the battery indicator reaches low

This is one of the most common complaints on the AE2510 and it is rarely the motor. A partially blocked filter forces the motor to draw more current than rated to maintain airflow. That elevated draw pulls the cell voltage down faster than normal, and the motor controller interprets the resulting voltage sag as a low-battery condition. The vacuum loses suction while the indicator still shows charge remaining. Clean or replace the filter first, then retest.

Battery fade after months of continuous dock charging

Ni-MH chemistry is particularly vulnerable to trickle charge damage. Leaving the AE2510 permanently docked runs a low-level charge current through cells that are already full, which gradually breaks down the cell structure and reduces total capacity. Users notice the vacuum running for a noticeably shorter time than it did when new, even with a fresh charge. To slow this down with the replacement cell, charge only when the vacuum is depleted and pull it from the dock once the charge cycle completes.