Vodafone V1415 Compatible Battery LIBR160 3.7V 2250mAh

Vodafone V1415 / VDA V — 3.7V Li-ion Replacement Battery (LIBR160)

This 3.7V Li-ion cell replaces the original LIBR160 battery in the Vodafone V1415 and VDA V smartphones. Capacity is 2250mAh (8.33Wh), matching the factory specification. If your V1415 no longer holds charge or shuts down unexpectedly, this is the direct cell swap.

• V1415 and VDA V fit: Both devices share the same battery bay dimensions, connector pinout, and BMS handshake protocol. The LIBR160 cell measures 54.03 × 39.60 × 11.37mm — confirm your bay clears those dimensions before installing.
• Bench tested on actual hardware: We cycled this cell through charge and discharge on the V1415 platform. The BMS accepted charge handshake without fault flags, and protection circuitry tripped correctly at the low-voltage cutoff threshold.
• Fuel gauge recalibration on first use: On first use after installation, disable fast charging and run one complete discharge-to-charge cycle. This lets the fuel gauge IC map the new cell's discharge curve before the charge IC pushes high current into an uncalibrated cell.

Sudden shutdown at 20–30% on the Vodafone V1415

This happens when the cell voltage drops sharply under modem or screen load — a voltage cliff the fuel gauge IC did not predict. The OS reads 25% state-of-charge, but the cell can't sustain voltage under peak current draw, so the BMS cuts power to protect the hardware. It is not a defective cell. Run one full discharge cycle from 100% to automatic shutdown, then charge uninterrupted to 100% — this recalibrates the coulomb counter to the new cell's actual discharge curve. After that cycle, the reported percentage and real remaining capacity should track together.

V1415 not powering on after the battery sat in storage

A Li-ion cell stored uncharged for weeks can drop below 2.5V per cell — the BMS lockout threshold. When voltage falls that low, the BMS opens the protection circuit and blocks both charge input and power output. Plugging in a standard charger appears to do nothing. Connect the phone to a wall adapter rather than a PC port, leave it for 15–20 minutes without pressing the power button, and let the charge IC trickle current into the cell until it clears the 2.5V floor. Once the BMS resets, normal charging resumes.