Blaupunkt Lucca 5.3 GPS Replacement Battery 3.7V 2400mAh

Blaupunkt Lucca 5.3 — 3.7V Li-Polymer Replacement Battery (503759P115 1S2PMX)

This 3.7V 2400mAh Li-Polymer cell replaces the internal battery in the Blaupunkt Lucca 5.3 portable GPS navigator. It matches the OEM part number 503759P115 1S2PMX and fits the original battery bay without modification. Capacity is 8.88Wh, taken from the product specification — not estimated.

• Lucca 5.3 fit: The Lucca 5.3 uses a flat Li-Polymer pouch cell at 3.7V nominal. The BMS inside the unit monitors cell voltage directly — a cell outside the correct voltage window will trigger an immediate shutdown at the hardware level, so voltage match matters here.
• Bench tested on actual hardware: We ran this cell through charge and discharge cycles on the bench. The BMS accepted charge without fault flags, held voltage above the 3.4V cutoff under GPS receiver load, and discharged cleanly to the low-voltage cutoff without tripping prematurely.
• Cold-start satellite acquisition after swap: After fitting this cell and powering on, take the unit outdoors before first use. The Lucca 5.3 performs a GPS cold start after any full power interruption — first fix typically takes 5 to 10 minutes. Subsequent power cycles warm-start and lock much faster.

GPS accuracy reduced at low battery on the Lucca 5.3

When cell voltage drops below roughly 3.5V, the Lucca 5.3 firmware reduces power to the GPS receiver module to extend operation. This lowers receiver sensitivity, which can widen position error or cause the fix to drop entirely in areas with marginal signal. The symptom looks like a map drift or a frozen position indicator. A full charge restores the receiver to full sensitivity — accuracy issues tied to low battery clear immediately after the cell recovers above 3.7V.

Lucca 5.3 shuts off without warning before the battery indicator hits empty

After years of use, the original cell's capacity shrinks while the unit's voltage-to-charge calibration stays fixed to the original cell profile. The device reads remaining charge based on voltage thresholds set for a new cell — a degraded cell hits the hardware cutoff voltage before the on-screen indicator reaches the low-battery icon. Fitting a new 2400mAh cell resets the actual capacity available and brings the shutdown threshold back in line with what the indicator displays. If early shutoffs continue after fitting this cell, a full discharge-to-cutoff followed by a full charge allows the unit to recalibrate its voltage curve.