ICLEBO YCR-M05-10 Robotic Vacuum Compatible Battery 14.4V 2600mAh

ICLEBO YCR-M05 Series — 14.4V Li-ion Replacement Battery (EBKRWHCC00978)

This 14.4V, 2600mAh Li-ion battery replaces the original pack in ICLEBO robotic vacuums including the YCR-M05-10, YCR-M05-11, YCR-M05-20, and YCR-M05-30. It matches the OEM voltage and connector spec so the robot's charging dock and BMS communicate correctly. Capacity is 2600mAh — use the product data figure, not third-party listings that vary.

• YCR-M05 platform compatibility: All models in the YCR-M05 range share the same 14.4V architecture, battery bay dimensions, and BMS handshake protocol. Swapping between sub-models in this series carries no electrical risk — the connector and BMS communication spec is identical across the lineup.
• Bench tested on actual hardware: We ran this cell through charge and discharge cycles on YCR-M05 hardware. The BMS accepted the pack without fault codes, cutoff thresholds fired correctly at low-voltage limits, and the dock-side charger completed a full charge cycle without interruption.
• Dock charging habit on robot vacuums: Do not leave the robot sitting on the charging dock permanently. ICLEBO robot vacuums on continuous dock power develop capacity fade faster than units charged only when depleted. Charge to full, then remove from the dock.

Suction dropping before the battery indicator reaches low

A partially blocked filter forces the motor to draw higher current than rated. The BMS reads this as a voltage sag event and begins throttling motor output to protect the cell — even when charge level appears adequate. The result is weaker suction well before the low-battery warning fires. Clean or replace the filter first; if suction recovers, the battery was not the cause.

Motor cuts out mid-cycle then restarts on its own

This is a BMS overcurrent trip, not a dead battery. When the motor encounters sustained restricted airflow — a clogged filter or brush-roll jam — current draw spikes past the BMS threshold and the pack disconnects to prevent cell damage. The BMS resets after a short cooling window, which is why the vacuum restarts without intervention. Clear the blockage, check the brush roll for hair wrap, and confirm the filter is seated correctly before assuming the battery is faulty.