Interstate ATEL0006 Cordless Phone Compatible Battery 3.6V 850mAh

Interstate ATEL0006 — 3.6V Ni-MH Replacement Battery for Cordless Phones

This Interstate battery replaces the ATEL0006 pack used in compatible cordless phone handsets. It runs at 3.6V with 850mAh capacity and uses Ni-MH chemistry — the same type as the original factory pack. If your handset is shutting off early or no longer holding a charge, this is the direct swap.

• Cordless phone handset fit: Cordless phones in this category share a 3.6V Ni-MH cell stack with a standard connector footprint. The ATEL0006 part number cross-references to handsets where the OEM and aftermarket packs use the same pin layout and BMS-free charge circuit, so the base station charges it through the same trickle-charge path as the original.
• Bench tested on actual hardware: We cycled this pack through charge and discharge on a 3.6V Ni-MH test rig. The cell voltage held within spec across five full cycles, and capacity climbed toward rated 850mAh by cycle three — normal Ni-MH behaviour from factory-fresh cells.
• First charge on install: After installing, seat the handset in the base and leave it for a full 16 hours before first use. Ni-MH cordless phone packs ship partially discharged. A slow initial charge lets the cells reach rated capacity — skipping it cuts your usable talk time from day one.

Talk time shorter than the original battery after replacement

Fresh Ni-MH cells often deliver below rated capacity for the first two to five cycles. The electrodes need repeated charge and discharge passes to reach full chemical activation — this is normal, not a defect. Each full cycle after install adds measurable capacity back. By cycle four or five, you should see talk time close to or matching the 850mAh rating.

Base station showing no charge or error light after swap

Ni-MH packs that have sat in storage can drop below the voltage threshold the base station expects to see before it starts charging. If the base shows an error light or no charge indicator, remove the handset, leave it out for 30 seconds, then re-seat it firmly. If the base still won't initiate, measure the pack voltage — it should read at least 3.0V. Below that, the base charge circuit may not trigger, and the pack will need a short external boost charge to recover.