Samsung Galaxy A13 5G EB-BA136ABY Compatible Battery 3.85V 4900mAh

Samsung Galaxy A13 5G — 3.85V Li-Polymer Replacement Battery (EB-BA136ABY)

This is a 3.85V, 4900mAh Li-Polymer replacement battery for the Samsung Galaxy A13 5G smartphone. It fits SM-A136B/N, SM-A136M/DS, SM-A136B/DSN, and related SM-A136 variants. OEM part numbers EB-BA136ABY and GH82-27431A both map to this cell.

• SM-A136 series compatibility: All SM-A136 variants share the same battery bay dimensions, connector pinout, and BMS handshake protocol. The 85.00 × 62.70 × 5.00mm cell fits flush without modification, and the BMS communicates correctly with the Exynos 850 power management IC on every listed sub-model.
• Bench tested on actual hardware: We ran this cell on SM-A136B hardware and monitored BMS behaviour through charge and discharge. The protection circuit held cutoff at the correct thresholds and the charge IC accepted the full 4900mAh rated capacity without error flags.
• Fuel gauge recalibration on first use: On first use after installation, disable fast charging and run one complete discharge-charge cycle at standard rate. This lets the fuel gauge IC recalibrate against the new cell's discharge curve before high-current charging pushes current into an uncalibrated cell.

Sudden shutdown at 20–30% on the Galaxy A13 5G after a cell swap

The Galaxy A13 5G uses a coulomb counter that was calibrated to the original cell's voltage-versus-capacity curve. A new cell has a steeper voltage cliff near the low end of its charge window. When the modem fires during a call or the screen brightness spikes, current draw pulls the cell voltage below the BMS cutoff threshold before the OS percentage reading reaches zero. The phone shuts down even though the gauge still reads 20–30%. One full discharge-charge cycle at standard rate resets the fuel gauge IC to the new cell's actual curve and eliminates the premature cutoff.

USB-PD fast charge not activating on the first cycle after replacement

Samsung's Adaptive Fast Charging protocol on the A13 5G requires the charge IC to read a valid BMS response before it steps up to high-current delivery. On a fresh cell, the BMS may not have completed its initialisation handshake on the first plug-in, so the phone defaults to standard 5V/1A trickle charge. This is not a fault with the charger or the cable. Complete one full charge cycle from under 10% to 100% at standard rate — on the second cycle, the BMS handshake completes and fast charging resumes at the expected voltage.